You will need the following:

• Mac SE/30 (of course)
• Asante MacCon RJ45 Ethernet Card (found ours on Ebay. *Note that these are becoming a rare.)
• Set of Torx Screwdrivers

Asante MacCon RJ45 Ethernet Main Card P/N 09-00005-00 REV. C2, AUI Daughter Card Rev C, 3 in 1 Daughter Board. Rev C

Remove programmers/reset switch plate from side of your SE/30 by carefully lifting the bottom upwards with your fingers. This shouldn't require a lot of force. Take note of slightly larger side air vents where switch plate attaches.

Place your SE/30 face down on a soft cloth. Remove four (4) torx screws with torx screwdriver as indicated by the arrows below. Carefully remove back of case by lifting upwards.

Step 3:

Remove heat shield from bottom of computer.

Mount daughter card (small card with ethernet ports) in chassis bay. Take note of cable orientation in picture below (blue side of cable is installed closest to ethernet ports.) Daughter card is mounted securely to SE/30 chassis with screws provided.

Carefully lower main card onto motherboard PDS socket. Push carefully but firmly into slot. The picture below shows correct seating of card.

Here is the Asante MacCon RJ45 ethernet correctly installed. Check that all connections are snug and secure (also check SCSI HD cable, floppy cable and power cable to motherboard). ** IMPORTANT** Take note of shock hazards when working near monitor connections!

Replace heat shield, computer case and programmer/reset switch. Your ethernet setup is now installed!